AUTOMIX SALT-X INJECTOR
For Outboards, Inboards, Stern Drives and Jet Skis
Salt X: SX50 is safe to use in your engines raw water cooling system and will not harm the environment. Laboratory and field tested Salt-X SX50 is proven to remove harmful salt deposits effectively and leaves a non oily sacrificial wax on the surface to protect your cooling system between uses.
Cooling System: During normal operation of your marine engine salt deposits buildup. If these deposits are not removed the engines ability to run at the right temperature is afected and over time can damage your engine. This is caused by reduced water flow and ineffective heat exchange. Salt-X will not harm impellors, gaskets or seals.
Corrosion: We all know how corrosive salt is and how quickly it can damage metal surfaces. Your engine cooling system is no different. Salt left in cooling galleries will eventually attack surfaces and corrode the thin gallery walls causing malor damage and high repair costs.
INSTRUCTIONS FOR USE
1. Connect Automix Injector between hose and cooling flush point (illustration on jet ski flushing). Water must be in direction of arrow on top of Auto mix unit.
2. Start engine and start water flow allowing engine to reach operating temperature. This will preflush any sand out and allow water to pass through thermostats if present.
3.With motor / water running remove dosage bowl and empty water. Add the recommended dosage of Salt-X for your engine and reinstall bowl.
4. Water will fill bowl again. Use the dosage table below to determine the time needed to deliver the SX50 into your cooling system. Once the Salt X is delivered turn off the water and then the motor.
Do not flush anymore water into cooling system.
SALT X YOUR COOLING SYSTEM AFTER EVERY TRIP & PRIOR TO STORAGE
Warranty: Whilst advice is given on the Salt-X products in good faith, no expressed or implied warranty is given on system as the use of it is beyond our control.